2-39
Description
Use the reboot member command to reboot a specified member device on the management device.
When a member device is in trouble due to some configuration errors, you can use the remote control
function on the management device to maintain the member device remotely. For example, from the
management device, you can delete the configuration file on a member device and reboot the member
device, and recover the device to the normal state with the backup configuration.
The eraseflash keyword specifies to delete the startup configuration file when the member device
reboots.
Examples
# Reboot number-2 member device.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] reboot member 2
snmp-host
Syntax
snmp-host ip-address
undo snmp-host
View
Cluster view
Parameters
ip-address: IP address of a SNMP network management station (NMS) to be configured for the cluster.
Description
Use the snmp-host command to configure a shared SNMP NMS for the cluster on the management
device.
Use the undo snmp-host command to remove the shared SNMP NMS setting.
By default, no shared SNMP NMS is configured.
After setting the IP address of an SNMP NMS for the cluster, the member devices in the cluster can
send trap messages to the SNMP NMS through the management device.
Note that, you can only use the commands on a management device.
For how to configure a switch to send trap messages to the SNMP NMS, refer to Information Center
Operation.
Examples
# Configure SNMP NMS address 1.0.0.9 on the management device for the cluster.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
To Next Page
Loading...
Need help?
General