2-7
display ntdp device-list
Syntax
display ntdp device-list [ verbose ]
View
Any view
Parameters
verbose: Displays the detailed information of devices in a cluster.
Description
Use the display ntdp device-list command to display the cluster device information collected by
NTDP.
Examples
# Display the list of devices collected by NTDP.
<Sysname> display ntdp device-list
MAC HOP IP PLATFORM
000f-e20f-3901 0 100.100.1.1/24 S3100
000f-e20f-3190 1 16.1.1.1/24 S3100
Table 2-3 Description on the fields of the display ntdp device-list command
Field Description
MAC MAC address of a device collected by NTDP
HOP Hops from this device to the collected device
IP
IP address and mask length of the management
VLAN interface on the collected device
PLATFORM Platform information about the collected device
# Display detailed device information collected by NTDP.
[1234_0.Sysname]display ntdp device-list verbose
Hostname : 1234_0.Sysname
MAC : 00e0-fc11-1111
Hop : 0
Platform : S3100
IP : 192.168.0.234/24
Version :
H3C Comware Platform Software
Comware Software, Version 3.10
Copyright(c) 2004-2010 Hangzhou H3C Technologies Co.,Ltd.All rights reserved.
S3100 3100-0002
Cluster : Administrator switch of cluster 1234
Stack : Candidate switch
Peer MAC Peer Port ID Native Port ID Speed Duplex
To Next Page
Loading...
Need help?
General