H3C S3100 Series Command Manual

1-21
When you use the display port-security command to display global information, the system will
display which types of trap messages are allowed to send.
Related commands: display port-security.
Examples
# Allow the sending of intrusion packet-detected trap messages.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] port-security trap intrusion
# Use the display port-security command to display the related configuration information.
<Sysname> display port-security
Equipment port-security is enabled
Intrusion trap is Enabled
Disableport Timeout: 20 s
OUI value:
Ethernet1/0/1 is link-down
Port mode is AutoLearn
NeedtoKnow mode is needtoknowonly
Intrusion mode is disableportTemporarily
Max mac-address num is 4
Stored mac-address num is 0
Authorization is ignore
The rest of the information is omitted, if any.
For description of the output information, refer to
Table 1-2.

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English