1-18
View
System view, Port group, Ethernet port view
Parameter
inbound: Duplicates inbound packets.
acl-rule: ACL rules to be applied. This argument can be the combination of multiple ACLs. For more
information about this argument, refer to
Table 1-9 and Table 1-10. Note that the ACL rules referenced
must be those defined with the permit keyword specified.
Table 1-9 Ways of applying combined ACL rules
ACL combination Form of the acl-rule argument
Apply a basic or advanced Layer 3 ACL
ip-group acl-number
Apply a rule in an Layer 3 ACL
ip-group acl-number rule rule-id
Apply all the rules in a Layer 2 ACL
link-group acl-number
Apply a rule in a Layer 2 ACL
link-group acl-number rule rule-id
Apply all the rules in an IPv6 ACL
user-group acl-number
Apply a rule in an IPv6 ACL
user-group acl-number rule rule-id
Apply a rule in an Layer 3 ACL and a rule in a
Layer 2 ACL
ip-group acl-number rule rule-id link-group
acl-number rule rule-id
Table 1-10 Description on the parameters used in
Table 1-9
Parameter Description
ip-group acl-number
Specifies the number of a basic or advanced ACL, in the range
2000 to 3999.
link-group acl-number
Specifies the number of a Layer 2 ACL, in the range 4000 to 4999.
user-group acl-number
IPv6 ACL number, in the range 5000 to 5999.
rule-id
ACL rule number, in the range 0 to 65534. If this argument is not
provided, all the rules in the ACL are specified.
cpu: Duplicates the packets to the CPU.
monitor-interface: Duplicates the packets to the destination mirroring port.
Description
Use the mirrored-to command to reference ACLs globally or to a port group or a port for identifying
traffics and perform traffic mirroring for packets that match.
Use the undo mirrored-to command to remove traffic mirroring configuration globally or for a port
group or a port.
Note that, the same ACL cannot be simultaneously referenced in both traffic mirroring configuration and
traffic redirecting configuration globally, in port group view, or in port view.
Related command: display qos-interface mirrored-to.