1-2
Ethernet1/0/1 inbound
reflector port: Ethernet1/0/2
remote-probe vlan: 10
# Display the configurations of a remote destination mirroring group on your S3100-EI series Ethernet
switch.
<Sysname> display mirroring-group 1
mirroring-group 1:
type: remote-destination
status: active
monitor port: Ethernet1/0/3
remote-probe vlan: 20
Table 1-1 Description on the fields of the display mirroring-group command
Field Description
mirroring-group
Port mirroring group number.
type
Port mirroring group type, which can be local,
remote-source, or remote-destination.
status
Status of the port mirroring group, which can be
active or inactive.
mirroring port
Source port in port mirroring. This field is
available only for local mirroring groups or
remote source mirroring groups.
both/inbound/outbound
The direction of the mirrored packets, which can
be one of the following:
z both: means packets received on and sent
from the mirroring port are mirrored.
z Inbound: means packets received on the
mirroring port are mirrored.
z outbound: means packets sent from the
mirroring port are mirrored.
monitor port
Destination port. This field is available only for
local mirroring groups and remote destination
mirroring groups.
reflector port
Reflector port. This field is available only for
remote source mirroring groups.
remote-probe vlan
Remote probe VLAN. This field is available only
for remote source/destination mirroring groups.
mirroring-group
Syntax
mirroring-group group-id { local | remote-destination | remote-source }
undo mirroring-group { group-id | all | local | remote-destination | remote-source }
View
System view
To Next Page
Loading...
Need help?
General