1-4
Parameter
group-id: Link aggregation group ID, in the range of 1 to 28 (only link aggregation groups configured
manually or statically are available).
master: Configures the specified link aggregation group as the master port of the Smart Link group.
slave: Configures the specified link aggregation group as the slave port of the Smart Link group.
Description
Use the link-aggregation group command to configure a link aggregation group as a member of the
Smart Link group.
Use the undo link-aggregation group command to remove the specified link aggregation group from
the current Smart Link group.
Because Smart Link and STP cannot be enabled on an Ethernet port at the same time, you must make
sure that STP is disabled on the port before assigning the port to a smart link group.
Example
# Configure link aggregation group 8 as the slave port of Smart Link group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] smart-link group 1
[Sysname-smlk-group1] link-aggregation group 8 slave
port
Syntax
port interface-type interface-number { master | slave }
undo port interface-type interface-number
View
Smart Link group view
Parameter
interface-type: Port type.
interface-number: Port number.
master: Configures the specified port as the master port of the Smart Link group.
slave: Configures the specified port as the slave port of the Smart Link group.
Description
Use the port command to configure the specified port as a member of the Smart Link group.
To Next Page
Loading...
Need help?
General