1-8
Field Description
VLAN name of VLAN 1 Name of VLAN 1
Auto-negotiation supported Indicates whether auto-negotiation is supported.
Auto-negotiation enabled State of auto-negotiation
OperMau Current speed and duplex state
Power port class
PoE device type, which can be:
z PSE: power sourcing equipment
z PD: powered device
PSE power supported Indicates whether or not the device can operate as a PSE.
PSE power enabled Indicates whether or not the device is operating as a PSE.
PSE pairs control ability Indicates whether or not the PSE-PD pair control is available.
Power pairs
PoE mode, which can be
Signal (PoE via signal lines) or Spare
(PoE via spare lines).
Port power classification
Port power classification of the PD, which can be the following:
z Class0
z Class1
z Class2
z Class3
z Class4
Link aggregation supported Indicates whether or not link aggregation is supported.
Link aggregation enabled Indicates whether or not link aggregation is enabled.
Aggregation port ID
Aggregation group ID, which is 0 if link aggregation is not
enabled.
Maximum frame Size Maximum frame size supported
Location format
Location information format, which can be:
z Invalid, indicating the format of the location information is
invalid.
z Coordinate-based LCI, indicating the location information is
coordinate-based.
z Civic Address LCI, indicating normal address information.
z ECS ELIN, indicating a telephone for urgencies.
Location Information Location information
PoE PSE power source
PSE
power type, which can be:
z Primary, indicating a primary power supply
z Backup, indicating a backup power supply
PoE service type PoE service type
Port PSE Priority
PoE power supply priority of PSE ports, which can be:
z Unknown
z Critical
z High
z Low
Port available power value
Available PoE power on PSE ports, in watts
Unknown basic TLV Unknown basic TLV
TLV type Unknown basic TLV type
To Next Page
Loading...
Need help?
General