1-23
vlan-id: ID of the VLAN in the TLVs (port and protocol VLAN ID TLVs or VLAN name TLVs) to be sent.
This argument ranges from 1 to 4094 and defaults to the least protocol VLAN ID.
dot3-tlv: Sends IEEE 802.3 organizationally specific LLDP TLVs.
link-aggregation: Sends link aggregation group TLVs.
mac-physic: Sends MAC/PHY configuration/status TLVs.
max-frame-size: Sends maximum frame size TLVS.
power: Sends power via MDI TLVs.
med-tlv: Sends MED related LLDP TLVs.
capability: Sends LLDP-MED capabilities TLVs.
inventory: Sends hardware revision TLVs, firmware revision TLVs, software revision TLVs, serial
number TLVs, manufacturer name TLVs, model name TLVs, and asset ID TLVs.
location-id: Sends location identification TLVS.
civic-address: Inserts the address information about the intermediate device in location identification
TLVs .
device-type: Device type value. A value of 0 specifies DHCP server; a value of 1 specifies switch, and a
value of 2 specifies LLDP-MED endpoint.
country-code: Country code, confirming to ISO 3166.
{ ca-type ca-value }&<1-10>: Configures address information, where ca-type represents the address
information type, in the range 0 to 255, ca-value represents address information, a string of 1 to 250
characters, and &<1-10> indicates that you can enter up to ten such parameters.
elin-address: Inserts telephone numbers for urgencies in location identification TLVs.
tel-number: Telephone number for urgencies, a string of 10 to 25 characters.
network-policy: Sends network policy TLVs.
power-over-ethernet: Sends extended power-via-MDI TLVs.
Description
Use the lldp tlv-enable command to configure advertisable TLVs for a port or all the ports in a port
group.
Use the undo lldp tlv-enable command to disable the sending of specific TLVs.
By default, all the TLVs except location identification TLVs are advertisable on a port.
Note that:
z To enable MED related LLDP TLV sending, you need to enable LLDP-MED capabilities TLV
sending first. Conversely, to disable LLDP-MED capabilities TLV sending, you need to disable the
sending of other MED related LLDP TLV.
z To disable MAC/PHY configuration/status TLV sending, you need to disable LLDP-MED
capabilities TLV sending first.
z Enabling the sending of LLDP-MED capabilities TLVs also enables the sending of MAC/PHY
configuration/status TLVs.
z You can specify to send multiple types of TLVs by executing the lldp tlv-enable command
repeatedly.
To Next Page
Loading...
Need help?
General