2-1
2 EAD Configuration Commands
Only the S3100-EI series switches support the EAD configuration.
EAD Configuration Commands
security-policy-server
Syntax
security-policy-server ip-address
undo security-policy-server { ip-address | all }
View
RADIUS scheme view
Parameters
ip-address: IP address of a security policy server.
all: IP addresses of all security policy servers.
Description
Use the security-policy-server command to set the IP address of a security policy server.
Use the undo security-policy-server command to remove one specified or all security policy server
address settings.
You can configure up to eight security policy server addresses in each RADIUS scheme. The switch
only responds to those session control messages that come from authentication server or security
policy server.
Examples
# Set a security policy server address 192.168.0.1 on the switch.
<Sysname>system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme extended
[Sysname-radius-extended] security-policy-server 192.168.0.1
[Sysname-radius-extended] display current-configuration
…
radius scheme extended
To Next Page
Loading...
Need help?
General