4-2
View
System view
Default Level
3: Manage level
Parameters
job-name: Name of a scheduled task, a string of 1 to 32 characters. You can configure multiple
scheduled tasks, with each task uniquely identified by the string. You can create up to 100 scheduled
tasks.
Description
Use the job command to create a scheduled task or enter scheduled task view.
Use the undo job command to remove a scheduled task.
Note that:
z After the job job-name command is successfully executed, you will enter the scheduled task view,
with the name [Sysname-job-string], for example, [Sysname-job-saveconfig]. After entering the
view, you can configure the parameters of the scheduled task.
z After the job job-name command is executed, if the corresponding task does not exist in the system,
this command creates a scheduled task; if the corresponding task exists in the system, this
command enables you to enter the existing scheduled task view. Then, you can configure the
parameters of the scheduled task.
Examples
# Create a scheduled task or enter an existing scheduled task view.
<Sysname> system-view
[Sysname] job saveconfig
[Sysname-job-saveconfig]
time
Syntax
time time-id { one-off | repeating } delay time command command
time time-id { one-off | repeating } at time [ week-day week-daylist | month-date month-day ]
command command
time time-id at time date command command
undo time time-id
View
Scheduled task view
Default Level
3: Manage level
Parameters
time time-id: Time record, where time-id is an integer ranging from 1 to 10, indicating that you can
configure up to ten time records for one scheduled task.
To Next Page
Loading...
Need help?
General