09/03
6-71
DC 3535/2240/1632, WC M24
780-xxx ESS Print Frame Setting NVM List
General Procedures and Information
Initial issue
780-036 Image Quality Control Category -
Heavy Weight 2 paper
27 4~31 27=Heavy Weight 2A; 28=Gloss 1C; 29=Gloss 1A; 30=Coated 1 Gloss; 31=Heavy Weight 2S
780-037 Image Quality Control Category -
Heavy Weight 2 paper (side 2)
200 4~200 200=Heavy Weight 2A; 34=Gloss 1C; 35=Gloss 1A; 36=Coated 1 Gloss; 33=Heavy Weight 2S
780-050 Paper Type Priority - Bond Paper 1 1=Bond paper has top priority; 2=Bond paper is second priority; 3=Bond paper is lowest priority
There are three paper type priority NVM locations (780-050, 780-051, and 780-052). Each location must have a
unique value.
780-051 Paper Type Priority - Plain Paper 2 1=Plain paper has top priority; 2=Plain paper is second priority; 3=Plain paper is lowest priority
There are three paper type priority NVM locations (780-050, 780-051, and 780-052). Each location must have a
unique value.
780-052 Paper Type Priority - Recycle Paper 3 1=Recycled paper has top priority; 2=Recycled paper is second priority; 3=Recycled paper is lowest priority
There are three paper type priority NVM locations (780-050, 780-051, and 780-052). Each location must have a
unique value.
780-053 Paper Type Priority - Custom Paper 1 1~8 Priority when not controlled by APS/ATS
780-054 Paper Type Priority - Custom Paper 2 1~8 Priority when not controlled by APS/ATS
780-055 Paper Type Priority - Custom Paper 3 1~8 Priority when not controlled by APS/ATS
780-056 Paper Type Priority - Custom Paper 4 1~8 Priority when not controlled by APS/ATS
780-057 Paper Type Priority - Custom Paper 5 1~8 Priority when not controlled by APS/ATS
780-060 Tray 1 Priority 1 1~4 The priority follows the number; 1 is the highest priority.
780-061 Tray 2 Priority 2 1~4 The priority follows the number; 1 is the highest priority.
780-062 Tray 3 Priority 3 1~4 The priority follows the number; 1 is the highest priority.
780-063 Tray 4 Priority 4 1~4 The priority follows the number; 1 is the highest priority.
780-066 Edge Erase Adjustment value (Lead
Edge)
40 40~50 4.0~5.0mm (0.1mm unit)
780-067 Edge Erase Adjustment value (Trail
Edge)
20 20~30 2.0~3.0mm (0.1mm unit)
780-068 Edge Erase Adjustment value (Side) 20 10~30 1.0~3.0mm (0.1mm unit)
780-069 Image Enhancement MC Setting 1 0~1 0=Off; 1=On
780-072 Offset operation of Center Tray 1 0~2 0=Offset Off; 1=Offset Per Set; 2=Offset Per Job
780-073 Offset operation of Finisher Tray 1 0~2 0=Offset Off;1=Offset Per Set; 2=Offset Per Job
Table 1 Chain 780
Chain-Link Name Default Range Description
To Next Page
Loading...
Need help?
General
