09/03
2-590
DC 3535/2240/1632, WC M24
102-318, 102-319
Initial issue
Status Indicator RAPs
102-318 Receive Finish Queue Full
The data received from the Controller exceeded the upper limit of the processing capability in
the Panel.
Procedure
Switch power off then on. The problem continues.
YN
Return to service call procedures.
Perform re-installation of the software.
102-319 Send with No ACK
Serial communication failure. Sending failure, ACK was not returned.
Procedure
Switch power off then on. Status code 116-325 is displayed temporarily, then 102-319 is
displayed.
YN
Status Code 102-319 is displayed.
YN
Return to service call procedures.
Perform re-installation of the software.
Go to the 116-325 RAP.
To Next Page
Loading...
Need help?
General
