09/03
2-20
DC 3535/2240/1632, WC M24
3-317 , 3-318
Initial issue
Status Indicator RAPs
3-317 IIT Software Failure
Configuration mismatch
Procedure
Change the position of the document sensor. The problem continues.
YN
Return to Service Call Procedures.
Rewrite the NVM values.
3-318 IIT Software Failure
Procedure
Switch the power off then on. The problem continues.
YN
Return to Service Call Procedures.
Reinstall the software. If the problem continues, check the ESS PWB connectors (P/J Loca-
tions, Figure 14). If the check is OK, replace the ESS PWB (PL 13.1).
To Next Page
Loading...
Need help?
General
