Xerox DocuColor 2240 Service Manual

09/03
2-291
DC 3535/2240/1632, WC M24
12-914
Status Indicator RAPs
Initial issue
12-914 Stacker Tray Staple Set
The Staple Set count of the Stacker Tray exceeded 50 sets at the Staple Set Eject operation.
Initial Actions
Check the actuator of the Stacker Paper Sensor for smooth operation (Figure 1).
Procedure
Remove the Stapled Sets. The problem continues.
YN
Return to Service Call Procedures.
Enter dC330 [012-200] and press Start. Actuate the Stacker Paper Sensor (Figure 2). The
display changes.
YN
Press Stop. Check the circuit of the Stacker Paper Sensor (Figure 2). Refer to the OF 99-
2 RAP for troubleshooting procedure.
Press Stop.
• Ensure that the connectors shown in the circuit diagram (Figure 2) are securely con-
nected and that the wires are not damaged.
• Replace the Stacker Paper Sensor (PL 17.11).
• If the problem persists, replace the Finisher PWB (PL 17.13) (Figure 3).
Figure 1 Component Location
Figure 2 12-914 RAP Circuit Diagram - Stacker Paper Sensor
Figure 3 Finisher PWB
Stack
Height
Sensor
Stacker
Motor
Stacker
Paper
Sensor

Xerox DocuColor 2240 Specifications

General

Brand	Xerox
Model	DocuColor 2240
Category	All in One Printer
Language	English