Xerox DocuColor 2240 - Staple Near Empty

09/03
2-298
DC 3535/2240/1632, WC M24
12-965
Initial issue
Status Indicator RAPs
12-965 Staple Near Empty
• The Low Staple Switch detected Low Staple at Power On and Interlock Close.
• The Low Staple Switch detected Low Staple at Staple Head Close.
Procedure
Install a new Staple Cartridge loaded with staples. +5VDC measured between the Finisher
PWB P/J852-4 and ground (Figure 1).
YN
Replace the Finisher PWB (PL 17.13).
+5VDC measured between the Stapler Assembly P/J886-2 and ground).
YN
Check the wire between the Stapler Assembly P/J886 and the Finisher PWB P/J852 for
an open circuit or poor contact.
Check the wire between the Stapler Assembly P/J886 and the Finisher PWB P/J852 for an
open circuit or poor contact.
If no problems are found, replace the Stapler Assembly (PL 17.9).
If the problem continues, replace the Finisher PWB (PL 17.13) (Figure 2).
Figure 1 12-965 RAP Circuit Diagram - Low Staple Sensor
Figure 2 Finisher PWB