09/03
2-42
DC 3535/2240/1632, WC M24
3-370, 3-747
Initial issue
Status Indicator RAPs
3-370 Marker Code Detect Failure
The end code cannot be found in the compressed data.
Procedure
Switch the power off then on. The problem continues.
YN
Return to Service Call Procedures.
Replace the RAM (PL 13.1).
Perform ADJ 9.8. If the problem continues, replace the HDD (PL 13.1).
If the problem persists, replace the ESS PWB (PL 13.1).
3-747 Print Instruction Failure
The print parameter is incorrect. This may indicate that a selected function such as finishing,
stapling, or duplexing is not available.
Procedure
Switch the power off then on. The problem continues.
YN
Return to Service Call Procedures.
Change the print parameter and print again.
To Next Page
Loading...
Need help?
General
