09/03
2-48
DC 3535/2240/1632, WC M24
3-951, 3-952
Initial issue
Status Indicator RAPs
Figure 2 3-951 RAP Circuit Diagram - Tray 2 No Paper Sensor (3TM)
3-952 Tray 3 Empty
Paper is not detected in Tray 3
Procedure
The machine is equipped with a 3TM.
YN
Remove Tray 3. Enter dC330 [007-122] and press Start. Actuate the Tray 3 No Paper
Sensor (PL 16.9). The display changes.
YN
Press Stop. Check the circuit of the Tray 3 No Paper Sensor (Figure 1). Refer to the
OF 99-2 RAP for troubleshooting procedure.
Press Stop.
• Go to the 7-291 RAP (TTM) and check the circuit of the Tray 3 Level Sensor.
• Ensure that the connectors shown in the circuit diagram (Figure 1) are securely con-
nected and that the wires are not damaged.
• Replace the Tray 3 No Paper Sensor (PL 16.9).
• If the problem persists, replace the Tray Module PWB (PL 16.15).
Remove Tray 3. Enter dC330 [007-122] and press Start. Actuate the Tray 3 No Paper Sensor
(PL 15.5). The display changes.
YN
Press Stop. Check the circuit of the Tray 3 No Paper Sensor (Figure 2). Refer to the OF
99-2 RAP for troubleshooting procedure.
Press Stop.
• Go to the 7-283 RAP and check the circuit of the Tray 3 Level Sensor.
• Ensure that the connectors shown in the circuit diagram (Figure 2) are securely con-
nected and that the wires are not damaged.
• Replace the Tray 3 No Paper Sensor (PL 15.5).
• If the problem persists, replace the Tray Module PWB (PL 15.9).
Figure 1 3-952 RAP Circuit Diagram - Tray 3 No Paper Sensor (TTM)
To Next Page
Loading...
Need help?
General
