1-35
Description
Use the hwping-server tcpconnect command to create a TCP listening service on the HWPing server.
Use the undo hwping-server tcpconnect command to remove the created TCP listening service.
When performing a TCP connection test on a specified port of an HWPing client, you must create a TCP
listening on the HWPing server if the server is an H3C S3100 series Ethernet switch; otherwise, the
TCP test may fail.
Related commands: hwping-server enable.
Examples
# Enable TCP listening, using 169.254.10.2 as the IP address and 9000 as the port number.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping-server tcpconnect 169.254.10.2 9000
hwping-server udpecho
Syntax
hwping-server udpecho ip-address port-number
undo hwping-server udpecho ip-address port-number
View
System view
Parameters
ip-address: IP address from which an HWPing server performs UDP listening.
port-number: Port from which an HWPing server performs UDP listening. The value ranges from 1 to
49999. In is not recommended to use some special ports (that is, those used for fixed functions, such as
port 1701). Otherwise, the HWPing test may fail.
Description
Use the hwping-server udpecho command to enable UDP listening on an HWPing server.
Use the undo hwping-server udpecho command to disable UDP listening.
When performing a jitter test or a UDP connection test on a specified port of an HWPing client, you must
enable UDP listening on the server if an S3100 switch serves as an HWPing server; otherwise, the test
may fail.
Related commands: hwping-server enable.
Examples
# Enable UDP listening, using 169.254.10.3 as the IP address and 9000 as the port number.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping-server udpecho 169.254.10.3 9000
To Next Page
Loading...
Need help?
General