H3C S3100 Series

1-1
1 Ethernet OAM Configuration Commands
Only the S3100-EI series support Ethernet OAM configuration commands.
OAM Configuration Commands
display oam
Syntax
display oam { local | remote } [ interface interface-type interface-number ]
View
Any view
Default Level
2: System level
Parameters
local: Displays the Ethernet OAM connection information of the local end.
remote: Displays the Ethernet OAM connection information of the remote end.
interface interface-type interface-number: Specify a port by its type and number.
Description
Use the display oam command to display the information about an Ethernet OAM connection,
including connection status, information contained in Ethernet OAM packet header, and Ethernet
OAM packet statistics.
If you do not specify the interface keyword, this command displays the information about all the
Ethernet OAM connections.
Related commands: reset oam.
Examples
# Display the information about the Ethernet OAM connection established on the local port Ethernet
1/0/1.
<Sysname> display oam local interface Ethernet1/0/1
Port : Ethernet1/0/1
Link Status : Up