H3C S3100 Series

1-1
1 CFD Configuration Commands
Only the S3100-EI series support CFD Configuration Commands.
CFD Configuration Commands
cfd cc enable
Syntax
cfd cc service-instance instance-id mep mep-id enable
undo cfd cc service-instance instance-id mep mep-id enable
View
Ethernet interface view
Default Level
2: System level
Parameters
service-instance instance-id: Specifies the service instance ID, ranging from 1 to 32767.
mep mep-id: Specifies the ID of a MEP, ranging from 1 to 8191.
Description
Use the cfd cc enable command to enable CCM sending on a specified MEP.
Use the undo cfd cc enable command to disable CCM sending on a specified MEP.
By default, the CCM sending function is disabled.
Related commands: cfd cc interval.
Examples
# On port Ethernet 1/0/1, Enable CCM sending on MEP 3 in service instance 5.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] cfd cc service-instance 5 mep 3 enable
cfd cc interval
Syntax
cfd cc interval interval-value service-instance instance-id
undo cfd cc interval service-instance instance-id