1-77
Parameters
ip-address: IP address of the secondary authorization server, a valid unicast address in dotted decimal
notation.
port: Port number of the secondary authorization server, ranging from 1 to 65535.
Description
Use the secondary authorization command to set the IP address and port number of the secondary
HWTACACS authorization server to be used by the current scheme.
Use the .undo secondary authorization command to restore the default IP address and port number
of the secondary HWTACACS authorization server, which are 0.0.0.0 and 49 respectively.
Note that:
z You are not allowed to set the same IP address for both primary and secondary authorization
servers.
z If you re-execute the command, the new setting will overwrite the old one.
z You can remove an authorization server setting only when there is no active TCP connection that is
sending authorization messages to the server.
Related commands: display hwtacacs.
Examples
# Set the IP address and UDP port number of the secondary authorization server for HWTACACS
scheme hwt1 to 10.163.155.13 and 49 respectively.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary authorization 10.163.155.13 49
timer quiet
Syntax
timer quiet minutes
undo timer quiet
View
HWTACACS scheme view
Parameters
minutes: Wait time before primary server state restoration, ranging from 1 to 255 minutes.
Description
Use the timer quiet command to set the time that the switch waits before it tries to re-communicate with
the primary server and restore the status of the primary server to active.
Use the undo timer quiet command to restore the default wait time.
By default, the switch waits five minutes.
Related commands: display hwtacacs.
To Next Page
Loading...
Need help?
General