1-78
Examples
# Configure the switch to wait 10 minutes before it tries to restore the status of the primary server to
active.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] timer quiet 10
timer realtime-accounting
Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
View
HWTACACS scheme view
Parameters
minutes: Real-time accounting interval, in minutes. It ranges from 3 to 60 and must be a multiple of 3.
Description
Use the timer realtime-accounting command to set the real-time accounting interval.
Use the undo timer realtime-accounting command to restore the default real-time accounting
interval.
By default, the real-time accounting interval is 12 minutes.
Note that:
z To control the interval at which users are charged in real time, you can set the real-time accounting
interval. After the setting, the switch periodically sends online users' accounting information to
TACACS accounting server at the set interval.
z The setting of the real-time accounting interval depends, to some degree, on the performance of
the switch and the TACACS server. The higher the performance of the switch and the TACACS
server is, the shorter the interval can be. It is recommended to set the interval as long as possible
when the number of users is relatively great (≥1000). The following table lists the recommended
intervals for different numbers of users.
Table 1-7 Numbers of users and recommended intervals
Number of users Real-time accounting interval
1 to 99 3
100 to 499 6
500 to 999 12
≥1000 ≥15
To Next Page
Loading...
Need help?
General