1-5
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator icmp
[Sysname-hwping-administrator-icmp] test-type icmp
[Sysname-hwping-administrator-icmp] destination-ip 169.254.10.3
destination-port
Syntax
destination-port port-number
undo destination-port
View
HWPing test group view
Parameters
port-number: Destination port number for an HWPing test, in the range of 1 to 50000.
Description
Use the destination-port command to configure a destination port number for an HWPing test.
Use the undo destination-port command to remove the configured destination port number.
By default, no destination port number is configured for a test.
Related commands: destination-ip.
z The destination-port command has effect on jitter, TCP-Private, and UDP-Private tests only.
z It is not recommended to perform a TCP, UDP, or jitter test on a well-known port (ports with a
number ranging from 1 to 1023). Otherwise, the HWPing test will fail or the corresponding service
of the well-known port will become unavailable.
Examples
# Set the destination port number for a tcpprivate test to 9000.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator tcp
[Sysname-hwping-administrator-tcp] test-type tcpprivate
[Sysname-hwping-administrator-tcp] destination-port 9000
display hwping
Syntax
display hwping { results | history | jitter } [ administrator-name operation-tag ]
View
Any view
Parameters
results: Displays results of the last test.
history: Displays the history records of tests.
To Next Page
Loading...
Need help?
General