RM0367 Rev 7 171/1043
RM0367 Power control (PWR)
172
Bit 4 VOSF: Voltage Scaling select flag
A delay is required for the internal regulator to be ready after the voltage range is changed.
The VOSF bit indicates that the regulator has reached the voltage level defined with bits VOS
of PWR_CR register.
This bit is set when VOS[1:0] in PWR_CR register change.
It is reset once the regulator is ready.
0: Regulator is ready in the selected voltage range
1: Regulator voltage output is changing to the required VOS level.
Bit 3 VREFINTRDYF: Internal voltage reference (V
REFINT
) ready flag
This bit indicates the state of the internal voltage reference, V
REFINT
.
0: V
REFINT
is OFF
1: V
REFINT
is ready
Bit 2 PVDO: PVD output
This bit is set and cleared by hardware. It is valid only if PVD is enabled by the PVDE bit.
0: V
DD
is higher than the PVD threshold selected with the PLS[2:0] bits.
1: V
DD
is lower than the PVD threshold selected with the PLS[2:0] bits.
Note: The PVD is stopped by Standby mode. For this reason, this bit is equal to 0 after
Standby or reset until the PVDE bit is set.
Bit 1 SBF: Standby flag
This bit is set by hardware and cleared only by a POR/PDR (power-on reset/power-down
reset) or by setting the CSBF bit in the PWR power control register (PWR_CR)
0: Device has not been in Standby mode
1: Device has been in Standby mode
Bit 0 WUF: Wakeup flag
This bit is set by hardware and cleared by a system reset or by setting the CWUF bit in the
PWR power control register (PWR_CR)
0: No wakeup event occurred
1: A wakeup event was received from the WKUP pin or from the RTC alarm (Alarm A or
Alarm B), RTC Tamper event, RTC TimeStamp event or RTC Wakeup).
Note: An additional wakeup event is detected if the WKUP pins are enabled (by setting the
EWUPx (x=1, 2, 3) bits) when the WKUP pin levels are already high.
To Next Page
Loading...
Need help?
General
