ST STM32L0x3 - ADC Main Features

RM0367 Rev 7 303/1043
RM0367 Analog-to-digital converter (ADC)
352
14.2 ADC main features
• High performance
– 12-bit, 10-bit, 8-bit or 6-bit configurable resolution
– ADC conversion time: 0.87 µs for 12-bit resolution (1.14 MHz), 0.81 µs conversion
time for 10-bit resolution, faster conversion times can be obtained by lowering
resolution.
– Self-calibration
– Programmable sampling time
– Data alignment with built-in data coherency
– DMA support
• Low-power
– The application can reduce PCLK frequency for low-power operation while still
keeping optimum ADC performance. For example, 0.87 µs conversion time is
kept, whatever the PCLK frequency)
– Wait mode: prevents ADC overrun in applications with low PCLK frequency
– Auto off mode: ADC is automatically powered off except during the active
conversion phase. This dramatically reduces the power consumption of the ADC.
• Analog input channels
– 16 external analog inputs
– 1 channel for internal temperature sensor (V
SENSE
)
– 1 channel for internal reference voltage (V
REFINT
)
– 1 channel for monitoring V
LCD
derived voltage (LCD_VLCD1 signal)
• Start-of-conversion can be initiated:
– By software
– By hardware triggers with configurable polarity (timer events or GPIO input
events)
• Conversion modes
– Can convert a single channel or can scan a sequence of channels.
– Single mode converts selected inputs once per trigger
– Continuous mode converts selected inputs continuously
– Discontinuous mode
• Interrupt generation at the end of sampling, end of conversion, end of sequence
conversion, and in case of analog watchdog or overrun events
• Analog watchdog
• Oversampler
– 16-bit data register
– Oversampling ratio adjustable from 2 to 256x
– Programmable data shift up to 8-bits
• ADC supply requirements: 1.65 to 3.6 V
• ADC input range: V
SSA
≤ V
IN
≤ V
DDA