09/03
6-60
DC 3535/2240/1632, WC M24
760-xxx Regicon NVM List
Initial issue
General Procedures and Information
760-069
DC3535
Skew Alarm threshold 30 0~255 Threshold of Skew amount; if this value is exceeded, it is registered as a failure. (2µm/bit)
760-070 Y-LD light volume at last RegiCon 0 0~1023 Laser Diode light quantity when Regi Control is performed.
760-071 M-LD light volume at last RegiCon 0 0~1023 Laser Diode light quantity when Regi Control is performed.
760-072 C-LD light volume at last RegiCon 0 0~1023 Laser Diode light quantity when Regi Control is performed.
760-073 K-LD light volume at last RegiCon 0 0~1023 Laser Diode light quantity when Regi Control is performed.
760-074 Y-XSO after LD light volume change 236 0~472 XSO value after correction based on the Laser Diode light quantity variation
760-075 M-XSO after LD light volume change 236 0~472 XSO value after correction based on the Laser Diode light quantity variation
760-076 C-XSO after LD light volume change 236 0~472 XSO value after correction based on the Laser Diode light quantity variation
760-077 K-XSO after LD light volume change 236 0~472 XSO value after correction based on the Laser Diode light quantity variation
760-078 Y-XBI after LD light volume change 0 0~3 XBI value after correction based on the Laser Diode light quantity variation
760-079 M-XBI after LD light volume change 0 0~3 XBI value after correction based on the Laser Diode light quantity variation
760-080 C-XBI after LD light volume change 0 0~3 XBI value after correction based on the Laser Diode light quantity variation
760-081 K-XBI after LD light volume change 0 0~3 XBI value after correction based on the Laser Diode light quantity variation
760-082
DC3535
Specified LD light quantity [Y] 0 0~1023 Current Laser Diode light quantity (LD light quantity specified by ROS)
760-083
DC3535
Specified LD light quantity [M] 0 0~1023 Current Laser Diode light quantity (LD light quantity specified by ROS)
760-084
DC3535
Specified LD light quantity [C] 0 0~1023 Current Laser Diode light quantity (LD light quantity specified by ROS)
760-085
DC3535
Specified LD light quantity [K] 0 0~1023 Current Laser Diode light quantity (LD light quantity specified by ROS)
760-090
DC3535
Frequency of RegiCon implemented at
the same time as ProCon
3 0~16 in what cycle RegiCon should be implemented at the same timing as ProCon during job
760-091
DC3535
YSO at Y-165mm/s 237 0~474 1 dot
760-092
DC3535
YSO at M-165mm/s 237 0~474 1 dot
760-094
DC3535
YSO at K-165mm/s 237 0~474 1 dot
760-095
DC3535
Y-X direction speed correction amount 17 0~32 1/4 dot
760-096
DC3535
M-X direction speed correction amount 17 0~32 1/4 dot
760-097
DC3535
C-X direction speed correction amount 16 0~32 1/4 dot
760-098
DC3535
K-X direction speed correction amount 16 0~32 1/4 dot
760-099
DC3535
Process speed at last Regi-Con 0 0~1 0=RegiCon last implemented at 104 or 52mm/s; 1=RegiCon last implemented at 165mm/sec.
760-100
DC3535
Y-Y margin speed switch variation 156 0~200 (Y margin variation amount when the speed is switched from 104 or 52mm/sec. to 165mm/s)-100, for Yellow
(1 µm/bit)
Table 1 Chain 760
Chain-Link Name Default Range Description
To Next Page
Loading...
