Xerox DocuColor 2240

09/03
2-394
DC 3535/2240/1632, WC M24
17-965, 17-966
Initial issue
Status Indicator RAPs
17-965 Stacker Tray Full
The Network Controller reports that the Stacker Tray in the Finisher is full.
Procedure
Empty the Stacker Tray. If the problem continues, go to the 12-960 RAP.
17-966 Mix Full Stack
The Network Control reports one of the following conditions:
• Compared to the maximum paper size that was loaded at the previous job, the paper size
(either feed direction or width direction) of the next job is bigger.
• Staple mode has been changed while the width of the maximum paper size that was
loaded at the previous job is less than 279.4mm.
• The maximum paper size that was loaded at the previous job is unknown.
Procedure
Empty the Stacker Tray. If the problem continues, go to the 12-961 RAP.