Xerox DocuColor 2240 - Page 49

09/03
2-16
DC 3535/2240/1632, WC M24
1-303
Initial issue
Status Indicator RAPs
1-303 RAP
The Tray Module Left Door is open.
Procedure
Enter dC330 [001-304] and press the Start button. Actuate the Tray Module LH Cover Interlock
Switch (PL 16.13) with a screwdriver. The Display changes state.
YN
+24 VDC is measured between the Tray Module PWB P/J554-3 (+) and GND (-).
YN
Refer to Figure 1 and check the wires from the Tray Module PWB P/J554-3 to Tray
Module Cover Interlock Switch FS813 for damage. If the wires are good, replace the
Tray Module Cover Interlock Switch (PL 16.13).
Replace the Tray Module PWB (PL 16.15).
Check the Switch Actuator and the Cover installation (PL 16.13).
Figure 1 1-303 RAP Circuit Diagram - Tray Module LH Cover Interlock Switch