Xerox DocuColor 2240 Service Manual

09/03
2-64
DC 3535/2240/1632, WC M24
4-347
Initial issue
Status Indicator RAPs
4-347 Transfer Belt Out of Position
The IBT Edge Sensor does not sense the Transfer Belt edge in the correct position.
Initial Actions
Check the following:
• Check that the IBT Belt Cleaner is not damaged, binding, or incorrectly assembled.
• Ensure that the Transfer Belt is clean and free from damage, especially the inboard edge.
• Check if the actuator for IBT Edge Sensor touches the belt edge; check actuator installa-
tion.
Procedure
Switch the power on. Enter dC330 [004-014] and press Start. Measure voltage between P/
J533-A11(+) on the I/F PWB and GND(-). Between +3 VDC and +1 VDC is measured.
YN
There is +5 VDC between P/J533-A9(+) and P/J533-A10(-) on the I/F PWB.
YN
Close the Front Cover. If the voltage between P/J533-A9(+) P/J533-A10(-) is less
than +5VDC, replace the MCU PWB (PL 13.1).
There is +5 VDC between P/J533-A11(+) on the I/F PWB and GND(-).
YN
0 VDC is measured between P/J533-A11(+) on the I/F PWB and GND(-).
YN
Refer to Figure 1. Check the wires from J533 on the I/F PWB to J119 on the IBT
Edge Sensor for damage or loose connections. If the wires are OK, replace the
IBT Edge Sensor (PL 5.4)
If the problem continues, replace the MCU PWB (PL 13.1).
Refer to Figure 1. Check the wires from J533 on the I/F PWB to J119 on the IBT
Edge Sensor for a short circuit. If the wires are OK, replace the IBT Edge Sensor (PL
5.4).
Refer to Figure 1. Check the wires from J533 on the I/F PWB to J119 on the IBT Edge
Sensor for an open circuit. If the wires are OK, replace the IBT Edge Sensor (PL 5.4).
+24 VDC is measured between P/J550-5(+) on the I/F PWB and GND(-).
YN
Go to the +24 VDC Wirenets and check +24VDC circuit up to P/J550-5 on the I/F PWB.
Remove the IBT Assembly. Enter dC330 [004-001] and press Start. The Steering Motor
energized.
YN
Refer to Figure 2. Check the wires from P550 on the I/F PWB to J207 on the IBT Steering
Motor for damage or a loose connection. If the wires are OK, Replace the MCU PWB (PL
13.1). If the problem continues, replace the I/F PWB (PL 9.1), and IBT Steering Motor (PL
1.3).
Check the IBT Belt installation (REP 9.22). If no problems are found, replace the MCU PWB
(PL 13.1).
Figure 1 4-347 RAP Circuit Diagram - IBT Edge Sensor
Figure 2 4-347 RAP Circuit Diagram - IBT Steering Motor

Xerox DocuColor 2240 Specifications

General

Brand	Xerox
Model	DocuColor 2240
Category	All in One Printer
Language	English