1-26
Examples
# Configure the source interface that sends test packets in DHCP tests as VLAN-interface 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator dhcp
[Sysname-hwping-administrator-dhcp] test-type dhcp
[Sysname-hwping-administrator-dhcp] source-interface Vlan-interface 1
source-ip
Syntax
source-ip ip-address
undo source-ip
View
HWPing test group view
Parameters
ip-address: Source IP address for a test.
Description
Use the source-ip command to configure the source IP address for the test.
Use the undo source-ip command to remove the configured source IP address.
By default, the IP address of the interface that sends test packets serves as the source IP address.
z For FTP tests, this command is required. This command does not apply to DHCP tests. For other
tests, this command is optional.
z The specified source IP address by this command cannot be of an interface on a remote device,
and the interface must be Up; otherwise the test will fail.
Examples
# Configure the source IP address as 169.254.10.2 for this ICMP test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator icmp
[Sysname-hwping-administrator-icmp] test-type icmp
[Sysname-hwping-administrator-icmp] source-ip 169.254.10.2
source-port
Syntax
source-port port-number
undo source-port
View
HWPing test group view
To Next Page
Loading...
Need help?
General