3
[sysname] interface Ethernet1/0/2
[sysname-Ethernet1/0/2] arp filter binding 192.168.100.1 000d-88f8-528c
arp max-learning-num
Syntax
arp max-learning-num number
undo arp max-learning-num
View
VLAN interface view
Parameters
number: Maximum number of dynamic ARP entries that can be learned by the interface. it ranges from
1 to 256.
Description
Use the arp max-learning-num command to configure the maximum number of dynamic ARP entries
that can be learned by the current VLAN interface.
Use the undo arp max-learning-num command to remove the configuration.
By default, the maximum number of dynamic ARP entries that can be learned by a VLAN interface is not
configured.
Note that:
z If you execute this command repeatedly, the last configured command takes effect.
z Among S3100 series switches, only S3100-EI series switches support the two commands.
Examples
# Configure the maximum number of dynamic ARP entries that can be learned by VLAN-interface 40 as
50.
<sysname> system-view
[sysname] interface vlan-interface 40
[sysname-Vlan-interface40] arp max-learning-num 50
ip source static import dot1x
Syntax
ip source static import dot1x
undo ip source static import dot1x
View
System view
Parameters
None
To Next Page
Loading...
Need help?
General