1-22
display cfd mp
Syntax
display cfd mp [ interface interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-type interface-number: Displays the MP information on a port specified by its port
type and port number.
Description
Use the display cfd mp command to display the MP information.
Note that:
z If no port is specified, this command displays the MP information on all ports.
z The information displayed is sorted by port name primarily in the ascending VLAN ID order within
the same port, and in the order of outward-facing MEPs (from low to high level), MIPs, and
inward-facing MEPs (from high to low level) within the same VLAN.
Examples
# Display the MP information on all ports.
<Sysname> display cfd mp
Interface Ethernet1/0/1 VLAN 100
MEP ID: 100 Level: 0 Service instance: 100 Direction: Outbound
Maintenance domain: mdtest0
Maintenance association: mainmd0
MEP ID: 105 Level: 5 Service instance: 105 Direction: Outbound
Maintenance domain: mdtest5
Maintenance association: mainmd5
MIP Level: 6 Service instance: 106
Maintenance domain: mdtest6
Maintenance association: mainmd6
MEP ID: 104 Level: 4 Service instance: 104 Direction: Inbound
Maintenance domain: mdtest4
Maintenance association: mainmd4
MEP ID: 102 Level: 2 Service instance: 102 Direction: Inbound
Maintenance domain: mdtest2
Maintenance association: mainmd2
Interface Ethernet1/0/4 VLAN 1
MEP ID: 9 Level: 6 Service instance: 6 Direction: Outbound
Maintenance domain: mdtest6
To Next Page
Loading...
Need help?
General