H3C S3100 Series Command Manual

1-1
1 Port Isolation Configuration Commands
Port Isolation Configuration Commands
display isolate port
Syntax
display isolate port
View
Any view
Parameter
None
Description
Use the display isolate port command to display the Ethernet ports assigned to the isolation group.
Example
# Display information about the Ethernet ports added to the isolation group.
<Sysname> display isolate port
Isolated port(s) on UNIT 1:
Ethernet1/0/2, Ethernet1/0/3, Ethernet1/0/4
The information above shows that Ethernet1/0/2, Ethernet1/0/3, and Ethernet1/04 are in the isolation
group.
port isolate
Syntax
port isolate
undo port isolate
View
Ethernet port view
Parameter
None
Description
Use the port isolate command to add an Ethernet port to the isolation group.
Use the undo port isolate command to remove an Ethernet port from the isolation group.

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English