09/03
9-7
DC 3535/2240/1632, WC M24
Foreign Interface Installation
Installation
Initial issue
Foreign Interface Installation
Purpose
The purpose of this kit is install a plug and play foreign interface accessory that will enable the
customer to attach a third-party vending device such as a debit machine or an external
auditron machine.
Kit Contents
Check the kit contents against the following list:
1. Foreign Interface
2. Kit Instructions
Prerequisites
For DC 2240/1632, the Foreign Interface kit requires machine S/W level 4.1 or higher (TAG
P2). If Tag P2 or higher software is not installed, use the CD to download the software (follow
the instructions on the CD), then mark off Tag 2 on the IOT Tag Matrix.
Ensure that the machine is fully operational.
Procedure
1. Switch off the machine and unplug the power cord(s) from the wall outlet.
2. On the rear of the machine:
a. Loosen the screw (Figure 1).
b. Rotate the cover (Figure 1).
c. Secure the cover by tightening the screw.
d. Ensure that the connector is completely exposed.
Figure 1 Cover on Rear of Machine
3. Locate the 10-pin connector (P343) (Figure 2).
Figure 2 Connector P343
4. Plug in the 10-pin connector (J343) from the Foreign Interface (Figure 3).
Figure 3 Connecting P/J343
5. Remove the backing from the Velcro™ on the rear of the Foreign Interface and attach the
the Foreign Interface in a convenient location on the rear of the machine.
6. Switch on the machine and confirm that the UI displays Insert Coin or Xerox Card.
7. If it is necessary to disable the Foreign Interface, change the value in NVM location 850-
001 from 1 to 0.
Screw
Cover
Connector
P343
J343 Connector/Harness
from Foreign Interface
To Next Page
Loading...
Need help?
General
