1-44
undo traffic-statistic vlan vlan-id inbound acl-rule
View
System view
Parameter
vlan-id: VLAN ID, in the range 1 to 4094.
inbound: Generates statistics on inbound packets.
acl-rule: ACL rules to be applied. This argument can be the combination of multiple ACLs. For more
information about this argument, refer to
Table 1-9 and Table 1-10. Note that the ACL rules referenced
must be those defined with the permit keyword specified.
Description
Use the traffic-statistic vlan command to generate statistics on packets that match specific ACL rules
and are of a specific VLAN.
Use the undo traffic-statistic vlan command to cancel the configuration.
Note that, for the same ACL rule, the traffic accounting function and the meter statistic keyword of the
traffic-limit command are mutually exclusive in a VLAN.
z Only H3C S3100-EI series switches support this command.
The traffic accounting function configured on a VLAN is only applicable to packets tagged with 802.1Q
header.
Related command: display qos-vlan, reset traffic-statistic vlan.
Example
# Generate statistics on packets that match ACL 2000 and are of VLAN 1 (assuming that the current
device is an S3100-EI series switch).
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 1.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-statistic vlan 1 inbound ip-group 2000
To Next Page
Loading...
Need help?
General