Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
139
Call up the command with the following parameters:
show wlan client-list [wlan 0/X [{mac <macaddr> | sys <sysname> | AID}]]
The parameter has the following meaning:
Keyword for the MAC address of the client -
Keyword for the system name of the client
Connection ID of the client.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The table with the logged-on clients is displayed.
show wlan client-list-vap (access point)
Description
This command shows the VAP interface via which the clients are logged on to the access
point in the form of a table.
Note
The command is available only in access point mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show wlan client-list-vap vapX 0/Y [AID]
To Next Page
Loading...
Need help?
General
