Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
290 Configuration Manual, 10/2015, C79000-G8976-C351-05
Call up the command with the following parameters:
no ip route <gateway>
The parameter has the following meaning:
Specifies the IP address of the gateway.
Specify a valid IP address.
The entry is deleted.
You configure an entry from the IP routing table with the ip route command.
You display the IP routing table with the
show ip route command.
With this command, you configure the read and write permissions for the DCP server and
enable it.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
dcp server {read-only|read-write}
The parameters have the following meaning:
only reading is permitted on the DCP
-
reading and writing is permitted on the
Default: read-write
The read and write permissions for the DPC server are configured.
The DCP server is enabled.
You disable the DCP server with the no dcp server command.
To Next Page
Loading...
Need help?
General
