Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
161
no wlan ampdu
Description
With this command, you disable the sending of AMPDU data packets. If the function is
disabled, only AMPDU data packets can be received.
● The IEEE 802.11n transmission standard is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call the command without parameter assignment:
no wlan ampdu
The sending of AMPDU data packets is disabled.
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
You enable the function with the
wlan ampdu command (default setting).
wlan ampdu (Page 160)
wlan ampdu bytes-limit
Description
With this command, you specify the maximum size of the AMPDU data packet in bytes.
Note
This command is available only in access point mo
de.
To Next Page
Loading...
Need help?
General
