Siemens SIMATIC NET Configuration Manual

Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
447
To enable the clients, use the client config command.
Note
Changing several message types or clients
With each command call, you can only select one message type and one c
lient.
If you want to process several message types or clients, it may be more efficient to first
select the all
option and then disable individual elements.
11.1.6.5
no event config
Description
With this command, you configure which of the various message types of the device will no
longer be stored or forwarded.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols