Security and authentication
10.3 Management Access Control List
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
430 Configuration Manual, 10/2015, C79000-G8976-C351-05
authorized-manager ip-source
Description
With this command, you configure the interfaces and protocols via which an authorized
manager is allowed to access the device.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
authorized-manager ip-source <ip-address>
[{<subnet-mask>|/<prefix-length(1-32)>}]
[interface[<interface-type<0/a-b,0/c,...>]
[<interface-type<0/a-b,0/c,...>]]
[vlan<a,b or a-b or a,b,c-d>] [service[snmp][telnet][http][https][ssh]]
The parameters have the following meaning:
Specifies the network or the IP address for
which the IP manager is authorized
Enter a valid IPv4 address or a
Subnet mask that restricts the authorization Enter a valid mask
Decimal representation of the mask as a number
of "1" bits
1 .. 32
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
Keyword for a VLAN connection
a,b,c-d
Number of a VLAN or VLAN range enter a valid VLAN or VLAN
Specifies the services for which the manager is
authorized.
You can select several options.
•
snmp
•
telnet
•
http
•
https
•
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The IP address 0.0.0.0 means "any manager"
To Next Page
Loading...
Need help?
General
