Configuration
3.3 Reset and Defaults
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
81
This section describes commands for restarting the device and for restoring the original
configuration.
With this command, you restart the device.
Select one of the following configuration settings:
● Device restart with the current configuration
● Device restart with the factory configuration settings with the exception of the following
parameters:
– IP addresses
– Subnet mask
– IP address of the default gateway
– DHCP client ID
– DHCP
– System name
– System location
– System contact
– User names and passwords
– Mode of the device
● Device restart with the factory configuration settings.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call up the command with the following parameters:
restart[{memory|factory}]
The parameters have the following meaning:
● if no parameters are specified: restarts the system with the current configuration
Resets the system to the factory configuration settings and restarts the system.
The parameters listed above are unaffected by a reset.
Resets the system to the factory configuration settings and restarts the system.
The device is restarted with the selected settings.
To Next Page
Loading...
Need help?
General
