Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
174 Configuration Manual, 10/2015, C79000-G8976-C351-05
wlan beacon interval (access point)
Description
With this command, you specify the interval at which the SCALANCE W700 device sends
beacons. Beacons are packets that are sent cyclically by an access point to inform clients of
its existence.
Note
This command is available only in access point mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan beacon interval <ms(40-1000)>
The parameter has the following meaning:
Length of the interval in milliseconds
40 ... 1000
The interval is specified.
You show the set interval with the show wlan advanced <wlan 0/X> command.
To Next Page
Loading...
Need help?
General
