Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
136 Configuration Manual, 10/2015, C79000-G8976-C351-05
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show wlan available-ap-list <wlan 0/X> [connected]
The parameters have the following meaning:
shows the information of the access points
with which the client is connected.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The access points to which the client can set up a wireless link are displayed.
show wlan basic
Description
This command displays the WLAN-basic configuration, for example, transmission standard,
frequency band.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
