Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
41
show ip interface
Description
This command shows the configuration of one, several or all IP interfaces.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ip interface
[{
vlan <vlan-id(1-4094)> |
<interface-type> <interface-id> |
loopback
}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available IP interfaces.
The configuration of the selected IP interface is displayed.
To Next Page
Loading...
Need help?
General
