EasyManuals Logo

Siemens SIMATIC NET Configuration Manual

Siemens SIMATIC NET
464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
65
The parameter has the following meaning:
Parameter
Description
Range of values / note
frame-size
Size of the MTU in bytes
64 ... 1514
At system start or when using the restart command with the option memoryor factory, the
following defaults apply:
The size of the MTU is configured to 1500 bytes.
Result
The setting for the size of the MTU is configured.
Further notes
You can shut down the interface with the shutdown complete command.
You display this setting with the
show interface mtu command.
You display this setting and other information with the
show interfaces command.
3.1.10.8
shutdown
Description
With this command, you shut down the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
shutdown complete

Table of Contents

Other manuals for Siemens SIMATIC NET

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC NET and is the answer not in the manual?

Siemens SIMATIC NET Specifications

General IconGeneral
CategoryIndustrial Communication Software
ManufacturerSiemens
Operating SystemsWindows, Linux
Protocols SupportedPROFIBUS, PROFINET, OPC UA
CompatibilitySiemens PLCs, Third-party devices with supported protocols

Related product manuals