Functions specific to SCALANCE
4.2 Signal recorder
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
94 Configuration Manual, 10/2015, C79000-G8976-C351-05
This section describes the commands relevant for working with the signal recorder.
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
show wlan signal-recorder (Client)
Description
This command shows the status of the signal recorder. You can call the command before,
after or during the recording.
Note
This command is only available in the client mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show wlan signal-recorder <wlan 0/X>
The parameter has the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
To Next Page
Loading...
Need help?
General
