Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
421
vap security encryption (access point)
Description
With this command, you enable encryption with a fixed (unchanging) WEP key. You can only
enable or disable encryption if you have selected "Open System" for authentication. All other
security methods include both authentication and encryption. If you use "Open system" with
"Encryption" or "Shared Key", you always need to specify the WEP key used for the
encryption.
Note
This command is available only in access point mode.
● The type of authentication is "open-system".
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Call the command without parameter assignment:
vap security encryption
The encryption is enabled. You can only disable encryption if you have selected "open-sytem"
for authentication
You display the settings with the show wlan security <vapX 0/Y> command.
You disable the encryption with the
no vap security encryption command.
You define a WEP key with the
wlan security edit key command.
With the
vap security default-key (Access Point)command, you configure the WEP key
used for encryption.
no vap security encryption (access point) (Page 422)
To Next Page
Loading...
Need help?
General
