Functions specific to SCALANCE
4.5 Spectrum analyzer
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
112 Configuration Manual, 10/2015, C79000-G8976-C351-05
wlan spectrumanalyzer stop (Access Point)
Description
With this command, you stop the recording with the spectrum analyzer .
Note
This command is available only in access point mode.
● The WLAN interface is enabled.
● A recording was started.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call the command without parameter assignment:
wlan spectrumanalyzer stop
The measurement was ended.
You start the recording with the wlan spectrumanalyzer start command.
To Next Page
Loading...
