Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
58 Configuration Manual, 10/2015, C79000-G8976-C351-05
3.1.9.11
system location
Description
With this command, you enter the location information for the system.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
system location <string>
The parameter has the following meaning:
Parameter
Description
Range of values / note
string
Input box for the location information
max. 255 characters
Result
The location information is created in the system.
3.1.9.12
system name
Description
This command, you enter a name for the system.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
system name <string>

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols