Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
160 Configuration Manual, 10/2015, C79000-G8976-C351-05
With this command, you enable the sending of AMPDU data packets. The function is
enabled as default.
● The IEEE 802.11n transmission standard is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call the command without parameter assignment:
wlan ampdu
The sending of AMPDU data packets is enabled.
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
You disable the function with the
no wlan ampdu command.
no wlan ampdu (Page 161)
To Next Page
Loading...
